Getting there with the Solstice

The Solstice is almost at the point where I can stop poking around on it and move over to the Morgan. Got the wiring cleared out of the driver’s side area, pulled off the steering wheel, and removed the ‘dash frame’ along with the upper half of the steering shaft that’s attached to it. As of now I just need to get the A/C system emptied out and remove the A/C stuff from the interior. Once that’s done I think it’ll be time to focus on clearing stuff off the back half of the Morgan and start sorting out how / if the Solstice’s rear end is going to swap in.

This entry was posted in Solstice Parts Car. Bookmark the permalink.

One Response to Getting there with the Solstice

  1. Dan says:

    I was going to ask… is this a Morgan project, or a Solstice project? 😉

Leave a Reply

Your email address will not be published. Required fields are marked *